The Ampere Audio AA-2.5 RVE Series is our newest line up for subwoofers and all built in house. The Ampere Audio AA-2.5 RVE 8″ was designed for 800w rms per driver. The lead wires are formed into the spider layers which further enhances durability and eliminates lead slap/breakage problems. The frame is cast aluminum with a sandblasted, powder coat finish. A large 2.5” copper coil in the motor reduces energy storage from inductance, with the side benefit of lowering distortion for “faster” response.
|Specifications||AA-2.5 8″ D2||AA-2.5 8″ D4|
|Displacement||0.1 ft^3||0.1 ft^3|
|Ported Enclosure ^3||.7 – .75 @ 34 – 39hz||.7 – .75 @ 34 – 39hz|
Xplicit Audio is proud to be an Authorized Ampere Audio Dealer!
|Dimensions||10 × 10 × 8 in|
In the event that an Ampere Audio Amplifier/Subwoofer fails due to a manufacturing defect, we will fix or replace it free of charge for a time period of one year from the date of purchase. This only applies to the original purchaser with original box and accessories must accompany. Warranties are non-transferable and amplifiers will not be covered under warranty if ran below a 1 ohm load or if underpowered by a weak electrical system. Failure to do so can decrease the life of the amplifier and void your warranty.
This warranty does not apply with respect to the following:
All returns must be sent with a RA # on the outside of the box in four place. Products sent without a RA will be refused and shipped back at the customers expense. The RA # can be obtained by contacting Ampere Audio and requesting the needed information.
Warranty claims must be accompanied by the original invoice to validate the warranty service or contact Ampere Audio for information.
Amplifier Repair: dB-r electronics