XS Power D4800
XS Power D4800 - 2000w Deep Cycle 12v Battery $309.00
Xplicit Audio Lanyard
Xplicit Audio Lanyard $4.00
5 out of 5 based on 2 customer ratings
(2 customer reviews )

In stock (can be backordered)

Sku:AA20001D

$509.00

In stock (can be backordered)

Brand:

The Ampere Audio AA-2000.1 is the perfect amplifier for someone trying to take the their sub stage to the next level. This amplifier gives you an over 2000w of monoblock power without having to upgrade your alternator and works perfectly for a wide variety of subwoofers, setups and competition classes.

Ampere Audio AA-2000.1D

  • Double Sided Through Hole Epoxy PCB
  • Daisy-Chain Through Output RCA (Strappable)
  • Efficiency: 86% @ 4 ohm, at 100Hz
  • 24dB/Oct Variable Crossover
  • Multi-Way Protection Circuitry
  • (Thermal/Over Current/Speaker Short/Speaker DC Protection)
  • Variable Subsonic
  • Variable Bass Boost
  • Variable Low Pass Filter
  • Variable Phase Shift
  • Zero(0) Gauge Power Supply Connectors
  • Tested Voltage & THD: 14.4V & Less than 1% THD
  • Operating Voltage: DC 10V~18V
  • Digital Class-D Linkable Mono Block Amplifier
  • 1 Ohm Stability
  • RCA Line Input and Master Output
  • 24dB Octave Crossover Slope
  • Wired Remote Controller

Technical Specs

  • Number of Channels: 1
  • Power 12.8 VDC – 1 ohm: 2,000W RMS
  • Power 12.8 VDC – 2 ohm: 1000W RMS
  • Power 12.8 VDC – 4 ohm: 500W RMS
  • Strapped Power 12.8 VDC – 2 ohm: 4,000W RMS
  • Input Sensitivity: 6V ~ 0.2V
  • Signal to Noise Ratio: 90dB
  • Frequency Response: 10Hz ~ 350Hz
  • Crossover: 24dB / Octave
  • Subsonic Filter: 10Hz ~ 60Hz
  • LPF (Low Pass Filter): 30Hz ~ 200Hz
  • Bass Boost @ 45Hz: 0 ~ 12dB
  • Phase Shift Control: 0 ~ 180 degree
  • Working Voltage: 10V ~ 18V
  • Efficiency: 86%
  • Recommended Fusing: 200A (external type fuse)
  • Dimensions: 252(W) x 58(H) x 494(L) mm

Recommended Power

For the Ampere Audio AA-2000.1, we recommend a minimum of an upgraded front battery as well as a secondary battery near the amplifier. All of which is connected by 1/0 OFC wiring.

Xplicit Audio is proud to be an Authorized Ampere Audio Dealer!

Weight18 lbs
Dimensions25 × 11 × 3 in

Warranty

In the event that an Ampere Audio Amplifier/Subwoofer fails due to a manufacturing defect, we will fix or replace it free of charge for a time period of one year from the date of purchase. This only applies to the original purchaser with original box and accessories must accompany. Warranties are non-transferable and amplifiers will not be covered under warranty if ran below a 1 ohm load or if underpowered by a weak electrical system. Failure to do so can decrease the life of the amplifier and void your warranty.

This warranty does not apply with respect to the following:

  1. Ampere Audio’s warranty does not cover burned/open voice coils or lead wires, ripped surrounds or folded cones.
  2. Defects or damage caused by environmental accidents.
  3. Products that have the serial numbers removed or altered.
  4. Products which have been altered or repaired by anyone other than Ampere Audio or dB-r.

All returns must be sent with a RA # on the outside of the box in four place. Products sent without a RA will be refused and shipped back at the customers expense. The RA # can be obtained by contacting Ampere Audio and requesting the needed information.

Warranty claims must be accompanied by the original invoice to validate the warranty service or contact Ampere Audio for information.

Amplifier Repair: dB-r electronics

Customer reviews

Rated 5 out of 5 stars
2 reviews
4 stars 0 0 %
3 stars 0 0 %
2 stars 0 0 %
1 star 0 0 %

2 reviews for Ampere Audio AA-2000.1D – 2000w Monoblock Amplifier

    Add a review

    Use one of the allowed file type: jpg,png.

      Back to Top