Ampere Audio AA-75.4
Ampere Audio AA-75.4 - 440w 4-Channel Amplifier $269.00
Ampere Audio AA-6.5SC - 100w RMS Speakers $169.00

In stock (can be backordered)

Sku:AA6001

$289.00

In stock (can be backordered)

Brand:

The Ampere Audio AA-600.1 is the perfect amplifier for any entry level setup looking to add a little bass to their ride. With such a small foot print, the AA-600.1 monoblock amplifier fits in most locations and in most vehicles.

Technical Specs

  • Number of Channels: 1
  • Power 14.4 VDC – 1 ohm: 600W RMS
  • Power 14.4 VDC – 2 ohm: 450W RMS
  • Power 14.4 VDC – 4 ohm: 280W RMS
  • Input Sensitivity: 6V ~ 0.2V
  • Signal to Noise Ratio: 90dB
  • Frequency Response: 25Hz ~ 200Hz
  • Crossover: 24dB / Octave
  • Subsonic Filter: 10Hz ~ 60Hz
  • LPF (Low Pass Filter): 35Hz ~ 300Hz
  • Bass Boost @ 45Hz: 0 ~ 12dB
  • Phase Shift Control: 0 ~ 180 degree
  • Working Voltage: 8.5V ~ 16V
  • Efficiency: 86%
  • Recommended Fusing: 30A x 2
  • Dimensions: 256(W) x 55(H) x 230(L) mm

Features

  • Double Sided Through Hole Epoxy PCB
  • Daisy-Chain Through Output RCA (Strappable)
  • Efficiency: 86% @ 4 ohm, at 100Hz
  • 24dB/Oct Variable Crossover
  • Multi-Way Protection Circuitry
  • (Thermal/Over Current/Speaker Short/Speaker DC Protection)
  • Variable Subsonic
  • Variable Bass Boost
  • Variable Low Pass Filter
  • Variable Phase Shift
  • 4 Gauge Power Supply Connectors
  • Tested Voltage & THD: 14.4V & Less than 1% THD
  • Operating Voltage: DC 10V~16V
  • Digital Class-D Linkable Mono Block Amplifier
  • 1 Ohm Stability
  • RCA Line Input and Master Output
  • 24dB Octave Crossover Slope
  • Wired Remote Controller

Recommended Power

For the Ampere Audio AA-600.1, we recommend a quality front battery. All of which is connected by 4ga OFC wiring.

Xplicit Audio is proud to be an Authorized Ampere Audio Dealer!

Weight1 lbs
Crossover

24dB / Octave

Efficiency

86%

LPF (Low Pass Filter)

30Hz ~ 200Hz

Dimensions

246(W) x 80(H) x 940(L) mm

Subsonic Filter

10Hz ~ 60Hz

Phase Shift Control

0 ~ 180 degree

Working Voltage

10V ~ 16V

Bass Boost @ 45Hz

0 ~ 12dB

Input Sensitivity

6V ~ 0.2V

Power 14.4 VDC - 4 ohm

2250W RMS

Power 14.4 VDC - 2 ohm

4500W RMS

Power 14.4 VDC - 1 ohm

9000W RMS

Frequency Response

10Hz ~ 350Hz

Number of Channels

1

Signal to Noise Ratio

90dB

Bridged Power 14.4 VDC - 2 ohm

1600W RMS

Warranty

In the event that an Ampere Audio Amplifier/Subwoofer fails due to a manufacturing defect, we will fix or replace it free of charge for a time period of one year from the date of purchase. This only applies to the original purchaser with original box and accessories must accompany. Warranties are non-transferable and amplifiers will not be covered under warranty if ran below a 1 ohm load or if underpowered by a weak electrical system. Failure to do so can decrease the life of the amplifier and void your warranty.

This warranty does not apply with respect to the following:

  1. Ampere Audio’s warranty does not cover burned/open voice coils or lead wires, ripped surrounds or folded cones.
  2. Defects or damage caused by environmental accidents.
  3. Products that have the serial numbers removed or altered.
  4. Products which have been altered or repaired by anyone other than Ampere Audio or dB-r.

All returns must be sent with a RA # on the outside of the box in four place. Products sent without a RA will be refused and shipped back at the customers expense. The RA # can be obtained by contacting Ampere Audio and requesting the needed information.

Warranty claims must be accompanied by the original invoice to validate the warranty service or contact Ampere Audio for information.

Amplifier Repair: dB-r electronics

Customer reviews

5 stars 0 0 %
4 stars 0 0 %
3 stars 0 0 %
2 stars 0 0 %
1 star 0 0 %

Reviews

There are no reviews yet.

Be the first to review “Ampere Audio AA-600.1 – 600w Monoblock Amplifier”

Use one of the allowed file type: jpg,png.

    Back to Top